Solids Control Equipments Manufacturer

Home > Service > shale shaker operation and use

shale shaker operation and use

2012-11-14

Before starting the check

 

Around the shaker screen box have influence machine obstacles, screen surface if there is a foreign body, if there is a should be cleared up

 

shaker screen is clean. If not clean, the application of water and brush to clean

 

Motor fixed bolt if there is loose

 

shaker screen whether tension

 

Power line is connected and the cable sheath whether have damage, earthing line are in good condition

 

If motor and good grease

 

starting up

Check and correct, and then it can be boot. Power on first 5 minutes should be carefully observed vibration situation, if found to have abnormal sound or vibration

Should immediately stop check, wait for after the trouble clearing any boot.

 

Normal work

 

Boot run idle for 5 minutes all normal then can feed work. Continuous work 30 minutes, should check the motor shell temperature rise.

Less than 50 degrees Celsius is normal, otherwise should be stop check processing.

 

In the process of work should be often through the see, hear, touch method to observe the machine work situation, if discover the anomaly should be timely stop check processing.

 

stop

 

Stop should be closed before admission valve, stop feeding. With water and brush will screen after cleaning, can stop.

 

In the process of work should be often through the see, hear, touch method to observe the machine work situation, if discover the anomaly should be timely stop check processing.

 

Safety matters needing attention

 

Lifting, be sure to use two root length quite, strength enough rope, in order to ensure safety equipment.

Shale shaker electrical installation must be qualified professional electrical charge, and strictly according to electrical installation standard.

 

Motor should be reliable grounding

 

Shale shaker electrical control box must explosion-proof and contain leakage, lack of phase, over current, short circuit protection function etc.

 

All mechanical or electrical maintenance and adjustment must ensure that the cut off the power supply, stop under the condition of (shaker screen box Angle adjustment except), in case accident!